Processing image From Fujitsu X-T3

I've got a two problems with the processing of an image from a Fuji X-T3.

1. It has a black border on the right hand side.

2. It takes about 40 seconds to process using: dcraw_emu -t 0 -4 -j -v -v "DSCF3954(X-Trans).RAF" which I think does three pass interpolation. By huge contrast Adobe Camera Raw 11.3 takes about two seconds even though the image is clearly interpolated (and quite well).

I totally understand that most of the 40 seconds is the interpolation time as dcraw_emu -t 0 -4 -j -disinterp -v -v "DSCF3954(X-Trans).RAF" only takes a couple of seconds.

Is there anything I can do to speed this up without compromising the quality (this is a release build).

Thanks

Forums: 

There are several

There are several interpolation options for X-Trans (from fastest to slowest):
- half
- bilinear
- single pass Markesteijn
- 3-pass Markesteijn

-- Alex Tutubalin

Followup:

Followup:

black border: X-T3 is supported since 201812 snapshot, what exact LibRaw version do you use?

-- Alex Tutubalin

19.2 Cheers

19.2

Cheers

David Partridge